Juniper 1-Port Serial Mini-PIM Especificaciones descargar pdf (Pagina 58)

Using the CLI

To perform basic configuration for the 1-Port ADSL2+ Mini-PIM and to configure network

interfaces for the services gateway with the CLI:

•

Verify that the serial interface is installed on the device:

show chassis hardware

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address:

set interfaces at-1/0/0 unit 0 family inet address interface address/destination prefix

•

Add or select a security zone; for example, Trust:

set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic protocol options:

set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic protocols

all

•

Set security policies:

set security policies default-policy permit-all

See the Junos OS Network Interfaces Configuration Guide for more details.

Documentation

• 1-Port ADSL2+ Mini-Physical Interface Module Overview on page 33

• 1-Port ADSL2+ Mini-Physical Interface Module Hardware Specifications on page 34

• 1-Port ADSL2+ Mini-Physical Interface Module Network Interface Specifications on

page 35

• 1-Port ADSL2+ Mini-Physical Interface Module Supported Standards on page 36

• 1-Port ADSL2+ Mini-Physical Interface Module Key Features on page 37

• 1-Port ADSL2+ Mini-Physical Interface Module LEDs on page 37

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 263 264

Sin comentarios

Juniper 1-Port Serial Mini-PIM Especificaciones Pagina 58