Juniper DPCE-R-Q-40GE-SFP Ficha de datos Pagina 169

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 168
You can install any transceiver supported by the PIC. For information about installing and removing
transceivers, see the hardware guide for your router.
Fiber-optic small form-factor pluggable (SFP) transceivers:
Connector: Duplex LC/PC (Rx and Tx)
SONET/SDH OC3/STM1 SFPs:
Multimode (model number: SFP-OC3-SR)
Intermediate reach (IR-1) (model number: SFP-OC3-IR)
Long reach (LR-1) (model number: SFP-OC3-LR)
Optical interface specifications—see SONET/SDH OC3/STM1 Optical Interface Specifications
SONET/SDH OC12/STM4 SFPs:
Short reach (SR-1) (model number: SFP-OC12-SR)
Intermediate reach (IR-1) (model number: SFP-OC12-IR)
Long reach (LR-1) (model number: SFP-OC12-LR)
Optical interface specifications—see SONET/SDH OC12/STM4 Optical Interface
Specifications
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links,
take the PIC offline until you are ready to establish a link to another device. For information about
taking a PIC offline, see the request chassis pic offline command in the Junos OS Operational Mode
Commands.
Cables and connectors
One tricolor per port:
Off—Not enabled
Green—Online with no alarms or failures
Yellow—Online with alarms for remote failures
Red—Active with a local alarm; router has detected a failure
LEDs
169Copyright © 2013, Juniper Networks, Inc.
SONET/SDH OC3/STM1 (Multi-Rate) PIC with SFP
Vista de pagina 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 197 198

Comentarios a estos manuales

Sin comentarios